Nová pravidla IPSC



spawny
Příspěvky: 12

Příspěvek#1 » pon 20. led 2014, 17:55

Máte někdo nová pravidla IPSC pro krátkou zbraň. Našel jsem jen pravidla pro rok 2009. Je tam od té doby nějaká změna ?



Walker
Příspěvky: 9
Kontaktovat uživatele:

Příspěvek#2 » pon 20. led 2014, 20:24




spawny
Příspěvky: 12

Příspěvek#3 » pon 27. led 2014, 22:35

Díky



Aurinko
Příspěvky: 19

Příspěvek#4 » stř 9. bře 2016, 20:39

Máte někdo nová pravidla pistole 2015 v češtině?



majlont
Příspěvky: 195

Příspěvek#5 » stř 15. srp 2018, 19:22

Chtěl bych začít s IPSC a udělat si bezpečnostní zkoušku APS ČR pro IPSC. Studuji Test pro bezpečnostní zkoušku + Soutěžní pravidla pro krátkou zbraň - vydání leden 2017 (obojí aktuálně staženo z http://www.asdscr.cz). Na následující tři otázky z testu nemohu v pravidlech najít odpověď:

1/ Popište vaši činnost po povelu a uveďte článek pravidel - IF CLEAR, HAMMER DOWN, OPEN THE ACTION
2/ Popište vaši činnost po povelu a uveďte článek pravidel - HAND CROSS
3/ Odpovězte stručně na následující otázku a uveďte článek pravidel, který upravuje danou situaci či oblast - Jakým způsobem, kdy a kde můžete manipulovat se střelivem dle pravidel IPSC ?

Dokážete někdo poradit nebo potvrdit moji hypotézu, že se jedná o nesoulad zkušebního testu s pravidly ?



waritko
Příspěvky: 66

Příspěvek#6 » čtv 16. srp 2018, 07:21

Ohledně BZ a otázek z testu se hodně řešilo na střelectví, konkrétně http://www.strelectvi.cz/forum/faq-ipsc-t27-460.html

Řešily se tam na poslední straně všechny výše uvedené otázky.



majlont
Příspěvky: 195

Příspěvek#7 » čtv 16. srp 2018, 11:11

Našel jsem tam vše, co jsem potřeboval. Moc díky za tvoji reakci :-)



puntik
Příspěvky: 69

Příspěvek#8 » úte 15. led 2019, 19:11

Ahoj vsem,
Mel bych dotaz k novym pravidlum pro divizi Production v roce 2019.
Jde mi o "upravu" zbrane...
Takze rad bych nalepil Talon grip a pak bymenil spoust s vymenou udernikove pruziny /za 1.8kg/ ... Dle meho prekladu, bych mel stale s touto upravou zbrane vyhovet pravidlum.

Dik za odpoved :-)



MRBLUE
Příspěvky: 927

Příspěvek#9 » úte 15. led 2019, 21:01

Aku zbran ides upravovat? Aku spust? Ak neni origo, niesi PRD. Kam vsate presne chces dat polep?



puntik
Příspěvky: 69

Příspěvek#10 » úte 15. led 2019, 21:32

CZ P 10C ..polep na pažbičku, tak jak se talon grip prodava...a spoušť od topstrel...
co se týče spouště: strana 56 bod 18.4: "Aftermarket springs and trigger assemblies are permitted" Muj překlad: "Druhovyroba" (tedy ne originál) pružin a spoušťových mechanismů (tedy i spouště?) je povolena...



radim78
Příspěvky: 302

Příspěvek#11 » úte 15. led 2019, 23:25

talon na P10C? to jako VAZNE??? :)



mischanek
Příspěvky: 96

Příspěvek#12 » stř 16. led 2019, 05:01

A neni pro PRD pozadovany odpor na spousti 2,27kg ?

Uživatelský avatar
McFly
moderátor
Příspěvky: 1696
Kontaktovat uživatele:

Příspěvek#13 » stř 16. led 2019, 05:43

Minimální požadovaný odpor v PRD je opravdu 2,27Kg..

Uživatelský avatar
Albert
Příspěvky: 1011

Příspěvek#14 » stř 16. led 2019, 07:30

Minimální odpor je samozřejmě pouze na první ránu. Ale mám takový pocit že ten odpor byl v nových pravidlech snížen.



puntik
Příspěvky: 69

Příspěvek#15 » stř 16. led 2019, 07:33

Nechci být drzý, ale četli jste nová pravddla? Pro jistotu přidávám komplet Specials conditions pro divizi Production:

14. Only handguns listed as approved in the Production Division List on the IPSC website may be used in
Production Division. Note that handguns deemed by IPSC to be single-action-only are expressly prohibited.
The official IPSC protocol used to measure barrel length is described in Appendix E4b.
15. The minimum trigger pull must either be 2.27kg (5lbs.) for the first shot fired and no restriction for subsequent
shots fired, or 1.36kg (3lbs.) for every shot fired.
16. Handguns with external hammers must be fully decocked (see Rule 8.1.2.5), at the Start Signal. First shot
attempted must be double action. Competitors in this Division who, after the issuance of the Start Signal and
prior to attempting the first shot, cock the hammer on a handgun which has a loaded chamber, will incur one
procedural penalty per occurrence. Note that a procedural penalty will not be assessed in respect of courses of
fire where the ready condition requires the competitor to prepare the handgun with an empty chamber. In these
cases, the competitor may fire the first shot single action.
17. Original parts and components offered by the OFM as standard equipment, or as an option, for a specific model
handgun on the IPSC approved handgun list are permitted, subject to the following:
17.1 Modifications to them, other than minor detailing (the removal of burrs and/or adjustments unavoidably
required in order to fit replacement OFM parts or components), are prohibited. Other prohibited
modifications include those which facilitate faster reloading (e.g. racking or cocking handles, flared,
enlarged and/or add-on magwells, etc.), and/or adding stippling. Changing the original color and/or finish
of a handgun, and/or adding stripes or other embellishments is permitted.
17.2 Magazines accessible to a competitor during a COF must not contain more than 15 rounds at the Start
Signal. Identifying marks or decals, internal capacity limiters, bumper pads and additional witness holes,
which add or remove negligible weight to/from magazines, are permitted.
17.3 Sights may be trimmed, adjusted and/or have colors applied. Sights may also be fitted with fiber optic or
similar inserts.

18. Aftermarket parts, components and accessories are prohibited, except as follows:
18.1 Aftermarket magazines are permitted, subject to 17.2 above.
18.2 Aftermarket open sights (see Rule 5.1.3.1) are permitted, provided their installation and/or adjustment
requires no alteration to the handgun.
18.3 Aftermarket grip panels which match the profile and contours of the OFM standard or optional grip
panels for the approved handgun and/or the application of tape on grips (see Appendix E3a) are
permitted. However, rubber sleeves are prohibited.
18.4 Aftermarket springs and trigger assemblies are permitted.




Takže jde mi o bod 15.
15. The minimum trigger pull must either be 2.27kg (5lbs.) for the first shot fired and no restriction for subsequent
shots fired, or 1.36kg (3lbs.) for every shot fired.
Můj překlad: minimální odpor spouště je 5 lbs pro první výstřel a bez omezení pro následující výstřely. Nebo odpor 3 lbs pro všechny výstřely...Nejsem zběhlý v konstrukci zbraní - takže nevím, jestli druhý výstřel má menší odpor, či nikoli...

Zpět na

Kdo je online

Uživatelé prohlížející si toto fórum: Žádní registrovaní uživatelé a 5 hostů